- Directional Video Condenser Microphone
- Mounts to Standard Camera Shoe
- 3.5mm Mini Plug
- Studio-Quality Sound
- 9V Battery Powered
- Integrated Shock Mount
- Can Be Mounted on a Boompole
The VideoMic from Rode is a cost effective shotgun microphone that can easily be mounted on a video camera because it features an integrated shockmount that attaches to the camera's shoe. The VideoMic is lightweight, and when mounting on a camera it does not appear in the frame. Its super-cardioid polar pattern attenuates sounds from the sides. The result is a signal that sounds closer to the camera, even when shooting in noisy environments or at moderate distances.
A 3/8" thread at the base of the shockmount allows you to use the VideoMic on any standard boompole. With the addition of a longer 1/8" male to female stereo mini-plug cable (like the Rode VC1), and a boompole (Like the Rode Mini Boom), you can radically improve the audio in your video work. A special 1/8" mini-plug to XLR adapter (the Rode VXLR) is also available to use the VideoMic on a professional camera.
Replaceable rubber O-rings suspend the microphone on the shockmount and protect against noise due to movement and handling. An attached, coiled cable terminates to a 1/8" (3.5mm) mini output connection. The VideoMic features a condenser element that utilizes a standard 9 Volt battery (sold separately). The microphone will run for approximately 100 hours on a single battery.
- Barrel Canceling Pick Up
- The Rode Video Mic functions as a true line plus gradient microphone with a super-cardioid pattern in the front and a barrel that cancels side-audio. The result is maximum pick up of the source in highly ambient and noisy environments.
- Integrated Shock-Mount
- The VideoMic features a permanently attached shock mount with a camera mounting shoe underneath. The shock mount features replaceable rubber o-rings that protect against noise caused by abrupt movement and shock.
- High Pass Filter Switch
- A high-pass filter switch eliminates room ambiance and noise below 80Hz. This results in improved intelligibility while recording around machinery, wind or close proximities.
- Internal Power
- The condenser element is powered with a standard 9-volt battery for up to 100 hours (approximately).
Transducer | Condenser |
Polar Pattern | Super-cardioid |
Frequency Response | 40Hz - 20kHz Selectable HPF @ 80Hz / 12dB /octave |
Dynamic Range (Typical) | 114dB (per IEC651, IEC268-15) |
Signal-to-Noise Ratio | 74dB (1kHz rel 1 Pa; per IEC651, IEC268-15) |
Maximum Input Sound Level | 134dB (@ 1% THD into 1k ohm) |
Power Requirements | 9 Volt DC Alkaline |
Output Impedance | 200 ohms |
Output Connectors | Stereo mini jack - 1/8" (3.5mm) |
Pad | -10 and -20dB |
Low Frequency Roll-Off | 80Hz / 12dB octave |
Dimensions | 8.84 x 4.02 x 2.55" (250 x 102 x 65mm) (Length x Height x Diameter) |
Weight | 6.21 oz (176g) |